I'm using your JCo-Connector and found it surprisingly easy to use it to interface to SAP. However, I've run into...
By submitting your personal information, you agree that TechTarget and its partners may contact you regarding relevant content, products and special offers.
trouble when I tried to re-use a function from my repository, which has previously thrown an exception. I'm using a "RFC_READ_TABLE" call to read out data. If an exception occurred (e.g. "WHERE Bedingung hat unerwartetes Format"), then any subsequent calls using this function give the same error, no matter how I adjust the OPTIONS/FIELDS fields etc. The problem goes away once I disconnected and re-established the connection to SAP. Is there a known problem of not deleted exceptions (either in JCo or my RFC-function), could one "clear" a function without disconnecting/connecting again. Any hints would be very much appreciated, thank you!
Are you sure that you clear the table parameters completely before you retry? In that case, we would need source code to test this ourselves.
Dig Deeper on SAP Basis administration and NetWeaver administration
Have a question for an expert?
Please add a title for your question
Get answers from a TechTarget expert on whatever's puzzling you.